Wire splice connector sealed8/7/2023 ![]() ![]() Loose wires are common causes of household electrical fires. After installing the connector, tug on each wire to make sure is it held securely inside the connector. When you're working with previously connected wires, cut off nicked, scored, blackened or badly bent wire ends and re-strip the insulation before inserting the wires into connectors. Ensure that wire ends are clean and undamaged.Electrical tape does not take the place of wire insulation. Never try to correct the problem by wrapping the bare wires with electrical tape. If you can't cover the bare ends, you've stripped too much insulation or you haven't installed the connector properly. Cover bare wire ends completely with the connector.If a connector does not show the UL symbol on its packaging, don't even consider using it. Any electrical product worth its salt is UL tested and approved, and UL listing (indicating approval) is required by law for most electrical installations. UL, or Underwriters Laboratories, is the leading testing authority of electrical equipment in the U.S. Also, note that standard wire connectors are for use with solid and stranded copper wire only never use them with aluminum wire. For example, a large-size twist-on connector may be able to accommodate a minimum of two 14 AWG wires and a maximum of four 12 AWG wires. ![]() Wire size is expressed in its gauge, or AWG (American Wire Gauge) number. Follow the manufacturer's specifications for the correct size and number of wires for each size of connector. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |